|
The O-10 die set is used to
form an acute-angle offset
in one stroke. Whip-up
should be a consideration so
the sheet does not hit the
ram of the press brake.
|
|
|
|
O-11 Offset Forming Die Set |
|
The O-11 die set is used to
form a material thickness
offset. In addition large
radii and additional
clearance help keep tonnage
requirements to a minimum.
|
|
| |
O-12
Offset Forming Die Set |
|
The O-12 die set is used to
bottom bend special open
angle offsets.
|
|
| |
|
O-13 Offset Forming Die Set |
|
The O-13 die set is used to
air bend a special offset
when tonnage capacity is a
problem. Air forming,
however, will not give the
accuracy of shape that comes
from bottoming dies. |
|
| |
|
O-14 Offset Forming Die Set |
|
The O-14 die set is used
when the flange is
considerable shorter than
the offset being formed. The
forming angle is tipped to
reduce size of vee opening
and prevent bowing of offset
web. The gauging is more
accurate with this type of
die set rather than the
general purpose offset dies.
|
|
| |
|
O-15
Offset Forming Die Set |
|
The O-15 die set is used to
form a material thickness
offset. The leader on the
back side of the die limits
the distance of the offset
form the edge of the sheet;
however the leader is needed
to prevent spreading and to
keep the dies in line. |
|
| |
|
O-16
Offset Forming Die Set |
|
The O-16 die set is used to
form a material thickness
offset in heavy gauge
material. The offset will be
open angle because the
outside radii are too large
for the depth of the
offset. |
|
O-10 Acute
Offset Forming Die Set
