Home Contact FeedBack Site Map Caculators
 
Hemming Die Sets
 
About us
Piranha
Hankwang Lasers
Pivatic
Komatsu
W.A. Whitney
R-K Press Brake Dies
Baleigh Industrial
Bertsch
Automec
Wila Tooling
Used Machinery
 
 

90 Degree Punches
90 Degree Dies
Gooseneck Punches
30 Degree Punches
30 Degree Dies
Flattening Die Sets
Offset Forming Dies
Hemming Die Sets
Radius Die Sets
Channel Die Sets
Wiping Die Sets
Tipped Angle Die Sets
Rocker Die Sets
Corrugation Die Sets
Standing Seam Die Sets
Curling Die Sets
Box Forming Die Sets
Threeway and Fourway Dies
R-K Adjustable Vee Dies
R-K Ram Adaptors
R-K Brake Die Holders

 
 
 

 
 
 
H-1 Hemming Die Set

 

 

 Is a low cost hemming die set that forms a teardrop or an open hem in a single handling without die change or adjustment. The greatest length of fold-over is 2 inches. In the closing operation, the material must be tilted and held high enough in the die to enable the punch point to pass the bend edge formed previously. A slight bow in the length of the sheet can be anticipated.
bulletUsed for 18-gauge and lighter material.
H-2 Hemming Die Set

 

 

 Is a low cost hemming die set that forms a teardrop or an open hem in a single handling without die change or adjustment. In the closing operation, the material must be tilted and held high enough in the die to enable the punch point to pass the bend edge formed previously. A slight bow in the length of the sheet can be anticipated.
bulletUsed for 16-gauge and heavier material.
H-4 Hemming Die Set

 

 

 The H-4 hemming die set to bend the acute angle in the upper level and to close the hem in the lower level.
bulletUsed for 18-gauge and lighter material.
bulletClosing operation is adjustable for forming open or closed hems.
H-5 Hemming Die Set

 

 

 The H-5 hemming die set to bend the acute angle in the upper level and to close the hem in the lower level.
bulletUsed for 14-gauge and heavier material.
H-6 Hemming Die Set

 

 

 Is a combination set that eliminates whip-up of the material. This curbs operator fatigue which is an important safety factor.
bulletUsed for 18-gauge and lighter material.
H-7 Hemming Die Set

 

 The H-7 die set allows for a standard acute die set to be used as shown for hemming; In addition the middle section can be locked in the closed position emulating a standard die holder.
bulletClosing operation is adjustable for forming open or closed hems.
bulletThe middle section can be locked in the closed position and used as a standard die holder.
 

R-K Press Brakes Dies Information Request Form :

Select the items that apply, and then let us know how to contact you.

Send product literature
Send company literature
Have a salesperson contact me

Name
Title
Company
Address
State Zip
E-mail
Phone

   

 		  
 

Back Next
 
Copyright [2005] [Diamond Machinery Company]. All rights reserved