 |
CH-1 Channel Die Set |
|
Flatness
of channels can be obtained in
the CH-1 with constant pressure
from a spring-loaded pad. |
|
|
|
CH-2 Channel Die Set |
|
The CH-2
is used when the width of the
channel being formed does not
permit a spring pad in the die. |
|
 |
CH-3 Channel Die Set |
|
The CH-3
die set produces an accurate
channel with consistency due to
a spring pressure pad. Part
removal is made easier by
release wedges on the punch and
die. |
|
 |
CH-4 Channel Die Set |
|
The Ch-4
rocker channel die set is
utilized when a particular stock
or excessive radii are required.
This die set produces the given
amount of overbend required to
make the legs parallel. |
|
 |
CH-5 Channel Die Set |
|
The CH-5
die set is designed for radius
channels where overbend is built
into the punch and die to
compensate for springback. |
|
 |
CH-6 Channel Die Set |
|
The CH-6
die set forms a semi-hat channel
at the edge of a sheet. The
release wedge in the die and
hook stripper assures positive
part removal. |
|
 |
CH-7 Channel Die Set |
|
The CH-7
die set produces consistently
square corners in one hit due to
a spring pressure pad. Part
removal is made easier by
release wedges on the punch and
die. |
|
 |
CH-8 Channel Die Set |
|
The CH-8
open hat channel die set forms
an open hat channel in one hit.
The pressure pad assures
flatness in the bottom of the
channel and easy pat removal. |
|
| |
